Classic manicure

To perform classic manicure we will need:

- clipper manicure and/or cuticle scissors

- cuticle pusher

- manicure Spa bath

- warm water

- liquid soap or any special tool for baths

- remover cuticle

- nail file for natural nails

- grinder

- polisher

Shape the free edge. Most compare the length and give the same shape of the free edge. The file is held perpendicular to the free edge. Motion files from the corners of the nail to the center, filing in this way helps to prevent splitting of nails in the future.

How to determine the same length? Applied in turn to each other forefinger, middle and ring fingers. The distance from cuticle to free edge on all three fingers should be identical. The nail on his little finger should be about 1 mm shorter than the nails on these three fingers, the nail of the thumb is 1 mm long. Compare the length on both hands.

Back on dry cuticles dealer. Soak hands in the tub after soaking again pushing the cuticle, and then the axe just loop along the cuticle. The hatchet should fully stand on the nail plate. In any case, do not place the axe on the edge in any traumerei nail plate, at least leave scratches. From corner to corner of the nail with the passage of the hatchet nothing is supposed to do, if it does then you are well cleanse the nail plate, preparing it to work with scissors or wire cutters.

Apply to cuticle remover, endured the allotted time and put your hand in the tub of water.

Next, we will need scissors with rounded tips. These scissors are made specifically for removing the cuticle.

Spouts of scissors we grab the skin in the region of sine (angle of the nail near the cuticle). Note that the cutting blade of the scissors should be perpendicular to the nail plate. Do not flame them forward or back, otherwise you will get poor quality cut. Why poor? When the scissors is in the proper position, then the regrowth cuticle is smooth. And if the scissors will be inundated, the different layers of the skin will grow back in different ways, as well as leather will be thin, then thick, then thin it may break. As a result, you get a lot of unpleasant problems in the form of burrs.

Carefully processed cuticle scissors. try to cut the cuticle of one slice. That is not several pieces, and one. You should cut a thin strip of skin.

Now you need to check how well the processed area of the cuticle. To do this, you need to pull the skin in the direction opposite to the growth of the cuticle. So you see, I totally removed the dead skin. If you have something left, but you can modify this plot cutters.

If your cuticle is small, then please note that you will not be able to handle it with scissors. Therefore, it is necessary to use pliers. Fabric cutters, as well as the blade of the scissors should stand perpendicular to the nail plate. Also, if you are uncomfortable to run with scissors, you can use the wire cutters.

When processing the skin in the area of side rollers, the tool is cutting cloths to the nail plate. Pull the side bolsters to thoroughly remove dead skin. Work translational motions, not looking up from the skin. Only then will smooth skin without burrs. Don't tear the skin. If the skin is torn, it means that it is poorly sharpened and they cannot work.

After you have finished processing, do not apply cuticle oil at once, as it camouflages all possible flaws. Wait until dry hands and you will see what and where you have left unfinished. If you saw that, still something remains, moisten a finger or apply remover, and then modify the required sections.

Then apply oil or proceed to the varnish or gel polish.