Reasons peeling artificial nails

Most important - is the proper preparation of nails to build you should carefully push the cuticles and remove the pterygium.

Attention should also be paid to people with high side bolsters. Because in such cases often arise detachment. In cuticle much easier to get rid of detachments than the lateral ridges. So when you remove the pterygium carefully pull the side bolsters of the nail plate and thoroughly scrub pterygium hatchet trimmed pusher and nail file. Then you finally will remove the most common cause of peeling of artificial nails.

Next, carefully degrease the nail plate. If you or your client's hands are wet, you should not degrease both hands at once. Better handle on two fingers.

The same situation is with the primer. In the case of wet hands treatment is carried out on one or two fingers. Incidentally, in the case of very wet hands, you can use a combination of acid + acid-free primer. Try not to get a primer on the skin, it at least will cause irritation. Also do not use large amounts of primer.

The next point is the proximity of the material to the cuticle and side bolsters. the material should not reach them where 1 mm. If the material to flow to the skin, it will inevitably lead to detachment. You can put stuff as carefully as possible, so you do not have to cut a lot.

Sawdust. Take care to have the cuticle and side bolsters material comes to naught. This prevents the detachment, as the material is laid at a distance from the skin and at the same time is thin enough. Try also not to saw the material, because too thin coating also leads to a rejection of the material.

Finally topcoat. Do not go for the finish of the material already available, especially if you are using the finish without adhesive layer.

Be careful and accurate and you will forget about all loose.